WebGate NVS04S Installation & User Manual page 30

4) If configuration is normally finished, video of IP camera will be on screen.
< ote>
1. One NVS04S can use Private per each channel and Public mode concurrently.
2. If IP camera connect to vS04S, IP camera is transfered from normal mode to recording mode.
In recording mode, stream is restricted up to 2 and can not change it. In case that changing
stream in recording mode, user should change recording setup in recording channel of VS04S
which mapping IP camear.
3. To transfer from recording mode to normal mode, remove IP camera in VS04S and reboot.
Configure RTSP(Real Time Streaming Protocol) camera
Set the IP Camera of RTSP function as follows.
1) Input RTSP Function License in System Setting page.
2) 'Use RTSP Camera' menu is activated in each channel tap after entering 'RTSP Function License'.
3) Click 'Use RTSP Camera' in related channel then 'rtsp://' is appeared in 'IP Address' and 'User ID'
is activated.
4) Input the related 'RTSP address' in IP Address,'User ID', 'Password' and click 'Apply' at bottom,
Then RTSP Camera is connected.
30