Installation And Connection; Connecting & Running; Power Connection And Operation; Connect In Private Mode - WebGate NVS04S Installation & User Manual

Installation and Connection

5. Connecting & Running

5.1. Power connection and operation

(1) Connect LAN port of NVS04S to the network connected IP Camera as below.
(2) It starts booting with power on.
< ote>
1. It takes around 1 minute to boot NVS04S.
2. While it sties connection, 4 LEDs on the front panel starts lighting and all of them starts
flickering and the user can check HDD list at Disk Manager.

5.2. Connect in Private mode

(1) Connect the Ethernet cable between the Lan port and PC.
(2) Connect private port of NVS04 and hub connected to IP Camera
(3) Connect the power to IP camera after connecting AC power to NVS04S
(4) Execute Control Center Configuration Tool program at PC and configure the IP
camera connected to each channel.
(Refer the channel configuration with IP Camera at Configuration Tool at "8.1.3.2 IP Camera")
12