Table of Contents
Advertisement
5. Troubleshooting
y
Image is unstable or flickering
-
Use "
TIMINGS\H PHASE" to correct it.
-
Change the monitor color setting on your computer.
y
Image has vertical flickering bar
-
Use "
AUTO IMAGE" to make an adjustment.
-
Check and reconfigure the display mode of your graphic card to make it compatible with the projector.
Image is out of focus
y
-
Adjust lens focus to fit.
-
Make sure the projection screen is between the required distance.
The image is stretched when displaying 16:9 DVD title
y
-
When you play anamorphic DVD or 16:9 DVD, the projector will show the best image when the projector
display mode is set to 16:9 in the OSD.
-
If you play 4:3 format DVD titles, please change the format to 4:3 in the projector OSD.
-
If the image is still stretched, you will also need to adjust the aspect ratio by referring to the following:
-
Please setup the display format as 16:9 (wide) aspect ratio type on your DVD player.
Image is too small or too large
y
-
Adjust lens zoom to fit. If it does not fill the screen properly, please change the correct lens or change the
position of the projector.
y
Image has slanted sides
-
Reposition the projector so that it is perpendicular to the screen.
5.2 LED Indication Chart
42
Status LED
Off/STBY
On
Error
During Start-up
1 sec
1 sec
PGWX-62L/PGWU-62L/PGWX-62L-K/PGWU-62L-K - - 2015/03/06
1 sec
1 sec
1 sec
Advertisement
Table of Contents
