Advertisement
8+9). With a damp cloth, (not wet) wipe out ozone generator chamber, to remove any debris
which may be present.
5. Dry the plates completely by putting them in an oven for 15 minutes @ 350 deg F. (Do not
put them in the microwave!)
6. Once plates are inspected and dried, they may be reassembled. Place one mica sheet flat in
the palm of your hand (Figure 10), then set the inner screen in the exact center of mica sheet.
Then place the other sheet of mica on top forming a sandwich (Figure 11). With thumb and
index finger grasp mica sandwich approx. half way (be careful inner screen remains centered
at all times) and gently slide assembly back into outer screen (Figure 12).
Figure 10
Figure 11
Figure 12
REPLACING SERVICED PLATE IN MACHINE
1. Install plates in reverse order of removal being careful inner stainless steel screen remains
centered at all times.
2. Once plates have been reinstalled, ensure that the high voltage lead is clamped tightly in the
holding clip (Figure 4).
3. Clean intake filters if dirty, then plug unit in and test for proper operation.
4. If the plates are slightly damp, ozone production will be significantly diminished until the inner
fan dries the plates out. Let the unit run for 5 minutes and then verify the ozone output by smell.
TROUBLESHOOTING:
If unit makes a snapping or popping sound, ensure that the plates are centered. If it still makes a
snapping sound, turn down the variable control until the snapping sound stops. Snapping is more
common in very dry climates since an electrical charge can travel further in dry air.
Ensure upon
reinstallation that both inner and outer stainless steel are centered as close as possible, and that all
components of generator are clean, dry and damage free.
1. Fan works but no ozone:
A: Is the filter plugged?
B: Are the plates clean and dry? (refer to maintenance section) if unit does not work after cleaning it will
probably need to be sent in for service work.
C: A hole has formed in the corona plate causing a direct short. – Contact Ozone Solutions at 888-892-
0303 if this is suspected.
2. Unit snaps or sparks:
A: Are the plates clean and dry? (refer to maintenance section)
B: Is the center screen in the plate centered? (If screen is off center place back in center of plat, refer to
maintenance instructions for plate removal and replacement).
Advertisement
