Kenwood KDW45S13 Installation Instructions Manual page 10

installation
3. If required, the worktop of the dishwasher
can be removed. The height without
the worktop is 820 mm, the minimum
dimensions required to accommodate the
dishwasher within fitted kitchen furniture
units.
Do not connect the unit to the mains socket
before installation. Ensure you are not
installing the unit right in front of the mains
socket. This is to avoid potential damage to
the back of the unit.
4. The condensation strip must be fitted
to the underside of the worktop above
your dishwasher to protect it against any
moisture. Its purpose is to protect your
worktop's underside from steam rising from
the dishwasher.
• Ensure the surface is clean prior to
sticking the condensation strip to the
underside of the worktop.
• Remove the backing paper from the
condensation strip.
• Stick the condensation strip to the
underside of the worktop.
Failure to attach the condensation
strip could result in damage to the
underside of your worktop!
5. The worktop can be removed by removing
the fixing screws located at the rear of the
dishwasher. After removing the screws, lift
and push the worktop forward to release
the lugs from the front section of the
dishwasher. The polystyrene block and the
lugs should be saved for future use.
10
Eco Rinse
3in1 Intensive Normal
Delay 1/2 Load
Start
Power
Leave some space
Stick the Condensation Strip
under the worktop, where you
want to install the dishwasher.
Remove
Remove
Unscrew
Glass Rapid
Remove