Table of Contents
Advertisement
BioAxs 9800IR™ Installation & Operations Manual. Version 1.9
Chapter 2: Unpacking
When you are ready to install the BioAxs 9800IR™ you should unpack, identify and account for
all items shipped with your BioAxs 9800IR™ Access Control System.
Note Do not remove the BioAxs 9800IR™ from its shipping container until you are ready to install it.
Keep the Access Panel in the shipping container until you have determined where you will install it.
Caution When handling the BioAxs 9800IR™ Access Panel without the back box, wear an ESD-
preventive strap and use an antistatic mat to avoid possible ESD damage.
Unpacking the BioAxs 9800IR™ Access Control System
To unpack the BioAxs 9800IR™ Access Control System from the shipping container, follow these steps.
Your shipment should contain at least 2 boxes. Carefully remove or cut the tape that seals each shipping
container and open the top of the outer shipping containers.
Note: shipping stabilizer material may differ from illustration.
Figure 3 Unpacking
1
Accessory Box 1
2
Accessory Box 2
3
Foam brace / Shipping Stabilizer
Copyright ©2004 NextgenID, Ltd. All Rights Reserved
4
Door Commander Unit (DCM)
5
Foam brace / Shipping Stabilizer
6
BioAxs 9800IR™ Access Panel and Back Box Assembly
16
Advertisement
Table of Contents
