Side Panel (Right); Rear Panel - Roland R-88 Owner's Manual

Overview

Side Panel (Right)

25
Analog input (IN 1/L–IN 8/R) jacks
These are analog audio input jacks equipped with mic preamps.
Each of the XLR input jacks 1-8 can be used as a monaural input,
providing a total of 8 input channels. Alternatively, XLR input jacks 1
and 2, 3 and 4, 5 and 6, and 7 and 8 can be used as four stereo-input
channels. For details, refer to "Input Settings" (p. 28).
* This instrument is equipped with
balanced (XLR) type jacks. Wiring
diagrams for these jacks are
shown at right. Make connections
after first checking the wiring
diagrams of other equipment you
intend to connect.

Rear Panel

28
28
Security slot ( )
You can attach a commercial available security cable to this slot to
prevent theft.
http://www.kensington.com/
8
25 26
2: HOT 1: GND
3: COLD
26
[PHANTOM] switch
These switches turn on/off the phantom power that is supplied to
each XLR input jack.
* Always turn the phantom power off when connecting any
device other than condenser microphones that require
phantom power. You risk causing damage if you mistakenly
supply phantom power to dynamic microphones, audio
playback devices, or other devices that don't require such
power. Be sure to check the specifications of any microphone
you intend to use by referring to the manual that came with it.
(This instrument's phantom power: 48 V DC, 10 mA per channel)
27
Ground Terminal
Refer to "About the Ground Terminal" (p. 9).
29
Analog Output (OUT 3–OUT 8) jack
These are XLR balanced output jacks. As the audio output signal,
you can choose either specific tracks or the output of the internal
mixer (two-channel mix). The output level is fixed at +4 dBu.
* This instrument is equipped with
balanced (XLR) type jacks. Wiring
diagrams for these jacks are
shown at right. Make connections
after first checking the wiring
diagrams of other equipment you
intend to connect.
NOTE
Do not supply phantom power from an external device to these
output jacks.
27
29
1: GND 2: HOT
3: COLD