Slate; Slate Tone; Specifying The Output Destination For The Slate Tone; Slate Mic - Roland R-88 Owner's Manual

SLATE

You can use the [SLATE] switch (p. 6) on the front panel to activate
the slate mic (p. 6) or produce a slate tone.

SLATE TONE

If you slide the [SLATE] switch to the "TONE" position and hold it
there for two seconds, a slate tone will be produced.
The slate tone can be recorded on all tracks of the recorder.
The slate tone will continue sounding even after you release the
[SLATE] switch. It will turn off when you slide the switch once again.
Specifying the Output Destination for
the Slate Tone
1.
Choose [MENU] <SYSTEM SETUP>
Ú
ROUTING> .
<SLATE TONE> is located on page 5/6. Touch
2.
Select the output destination for the slate tone .
Output
Explanation
destination
MIX Output only to the internal mixer's output.
Output to the internal mixer's output and to all tracks
MIX+REC
of the recorder. The slate tone will not be output to
OUTPUT or to USB.
Output to the internal mixer's output, to OUTPUT, and
MIX+OUT
to USB. The slate tone will not be recorded.
Output to the internal mixer's output, to all tracks of the
ALL
recorder, to OUTPUT, and to USB.
50
<SLATE TONE
Ú
to access 5/6.

SLATE MIC

When you slide the [SLATE] switch to the "MIC" position and hold
it there for two seconds, the MIC indicator will light and the slate
mic will turn on. You can use the slate mic to record credits or
comments for the scene on each track of the recorder.
The slate mic will turn off when you release the switch.
Using the Slate Mic to Record on Desired
Tracks of the Recorder
1.
Choose [MENU] <SYSTEM SETUP>
Ú
OFF> .
<SLATE MIC ON/OFF> is located on page 5/6. Touch
5/6.
2.
Touch the icon for each channel to turn it on/off .
MEMO
• If the slate mic's track setting is ON, it will be output to all
destinations (recorder, OUTPUT jacks, and USB).
• For details about slate mic and slate tone routing, refer to "R-88
Block Diagram" (p. 74).
<SLATE MIC ON/
Ú
to access