TV+
THE INSTALLATION WIZARD
•
•
If you ever need to relaunch the Installation Wizard, press the reset button. The
relaunched.
ATTENTION: if you use the reset button and relaunch the wizard, no data will
be erased but your TV connection settings will be lost, and you will have to set
them up again through the wizard.
NAVIGATING INSIDE THE WIZARD
•
In the different screens of the wizard, use the up/down navigation buttons on the
remote control to highlight a parameter.
•
Use the left/right buttons to select a different setting for a parameter.
•
light "
" and press OK on the remote control to move on to the next screen.
Next
•
If you want to go back to a previous screen, select "
CONFIGURING THE WIFI/ETHERNET CONNECTION
•
At the end of the Installation Wizard, in the "
•
Choose "
", "
WiFi
"
", based on the way you want to connect to the Internet (or local network).
None
If you do not have access to the Internet, select "
•
See "Network" Settings .
TURNING THE ARCHOS ON/OFF
•
Press the Power button
it into standby mode.
•
The green LED indicator, on the front of the device, lights up when the device is
on. The red LED lights up when the device is in standby mode.
MANUAL
V1.0
" (standard Ethernet cable not supplied) or
Ethernet Cable
on the remote control to turn on your ARCHOS or put
".
Previous
" screen, you are invited to
Network
".
None
STARTING UP > P. 9
-