Table of Contents
Advertisement
TV+
4.
Select the "
Test power Off code
ARCHOS device will then try to turn your tuner off. After a few seconds, your
ARCHOS will ask you if the device responded correctly:
If your tuner turned off, select "
If your tuner did not turn off, select "
ing the tuner off again, using a different code. Repeat this operation until the
ARCHOS manages to turn the tuner off.
If none of the codes work, check that the ARCHOS is positioned in a way that
allows the infrared signal to reach your tuner's receiver. Note: In some rare
cases the ON/OFF functionality may not work.
nd
2
Test: changing channels on your tuner
After you select "
Yes
you to correctly set the parameters so that the ARCHOS can change channels on your
tuner (for a scheduled recording).
For the "
Channel
rized on your tuner.
2.
Select the "
Test channel select
ARCHOS device will then attempt to switch your tuner to the selected channel.
After a few seconds, your ARCHOS will ask you if the device responded correctly:
If this worked, select "
If this did not work, select "
switch your tuner to the selected channel, using a different option*. Repeat this
operation until it successfully changes the channel on your TV receiver.
*Here is a description of the different parameters automatically set by the ARCHOS:
"Key Delay": delay between the emission of each digit of a channel ("
-
"Key: Enter": Set to "
-
this parameter is set to "
MANUAL
V1.0
" button. Make sure that your tuner is on. Your
Yes
" parameter, select the highest channel that is currently memo-
" button. Make sure that your tuner is on. Your
".
Yes
No, try next option
" if normally, you have to press an "
On
".
On
", and move on to the next section.
No, try next code
test, the following screen appears. It allows
st
". Your device will try again to
" button on your turner's remote control
OK
THE TV PROGRAM GUIDE > P. 65
". Your device will try turn-
", "
", "
Short
Normal
Long
OK
").
Advertisement
Table of Contents
