Table of Contents
Advertisement
TV+
Connection Diagram for North America: *
* North America: If your TV does not have an S-video input connector, use a
standard male/male RCA cable (on the yellow video jack) instead of the sup-
plied S-video cable.
Connect the ARCHOS' outputs to your TV's inputs as shown above. If you have an
HDMI cable, you can connect it now.
2.
Connect the included power adapter to the jack labeled DC-IN on the back of the
ARCHOS.
3.
Then plug the other end of the power adapter into an available wall socket.
cally. The red LED indicator will start blinking while the device is starting. When
the ARCHOS is on, the green LED will light up.
this device (even if they give the same voltage rating).
4.
Make sure that your TV is switched to the AV input which the ARCHOS is con-
nected to (on the back of the TV).
5.
Once the ARCHOS turns on (green light), your device will cycle between three
different video output modes in order for you to select the correct one. Wait until
OK on the remote control.
6.
ARCHOS.
See TV Recording: Hardware Setup to learn how to connect a tuner to the ARCHOS
in order to schedule a TV recording (manually or via the TV Program Guide).
MANUAL
V1.0
STARTING UP > P. 8
-
Advertisement
Table of Contents
