Operating Oven Control; Shut Down Instructions - Winnebago Voyage 2005 User Manual

Table of Contents

Advertisement

WARNING
Do not turn burner control knob to
"On" and allow gas to escape before
turning ignitor knob.
Lighting Oven Pilot
NOTE: If range has not been operated for a long
period of time, a longer waiting period
for ignition of the pilot may be necessary
due to air in the gas line.
1. Be sure all valves are in the "OFF" Position.
The oven control knob should be in "OFF"
position.
2. Turn on LP tank supply valve.
3. Press and turn control knob to the "PILOT
ON" position. This will allow gas to oven
pilot.
4. Open oven door and light oven pilot with a
match. Small flame will be noted at the top
of the pilot burner.
APPLIANCES & EQUIPMENT
Lighting oven pilot (when pilot is
located on left side of burner.)

Operating Oven Control

Push in and turn the oven control knob (coun-
terclockwise) to the desired temperature setting.
There is a delay of about 45 seconds before the
main burner ignites. This is normal and there is
no gas escaping during this delay. It is also nor-
mal for the oven burner flame to cycle off and on
at all temperatures except broil (BR).

Shut Down Instructions

When you are done using the oven, turn the
knob to "Pilot On" position - not Off.
The Pilot On position will turn off the main
oven burner but leave the oven pilot burning. The
"Off" position will shut down the pilot light so
you would have to relight it before using the oven
again.
Turn the knob to the Off position and close the
main LP tank supply valve to shut the pilot light
down while the vehicle is in motion and during
storage periods.
MICROWAVE OVEN/RANGE HOOD
For complete operating instructions, refer to
the manufacturer's information provided in your
Owner InfoCase.
The range hood vent is built into the underside
of the microwave oven. The range hood fan car-
ries cooking odors and gas fumes to the outside
of the coach. A light on the underside of the hood
provides illumination for food preparation. The
hood fan and light switches are located on the mi-
crowave control panel.
SECTION 6
6-7

Advertisement

Table of Contents
loading

Table of Contents