Table of Contents
Advertisement
EdgeMarc 250AE Hardware Installation Guide
Caution
Do not mount the EdgeMarc vertically on the wall!
Connecting the Power and Cables
The EdgeMarc 250AE comes with an AC power cord for connecting the unit
to an AC outlet.
Warning
Always connect the AC power cord to an AC outlet suitable for the power
supply that came with the unit to reduce the risk of damage.
1.
Caution
Secure the AC power cord to a cable management system using a fastener
or tie wrap to insure the EdgeMarc does not hang from the AC outlet.
1.
Powering On the EdgeMarc
1.
2.
3.
10
Caution
Caution
Warning
Connect one end of the AC power cord to the EdgeMarc input power
socket and the other end to the AC outlet. You may need to apply a bit
of force to properly position the plug in the power socket.
Caution
Caution
If connecting to an Internet router, Internet DMZ switch, cable modem
or DSL modem, connect the Ethernet cable to the WAN Interface port
(Port 2) on the EdgeMarc and the other end to the WAN device.
Turn on the EdgeMarc power switch.
Make sure that the power and status LEDs on the front panel are solid
green after the EdgeMarc powers on.
Proceed to
Chapter 3, Configuring Basic Network
Settings.
© 2014 Edgewater Networks. All Rights Reserved.
Hide quick links:
Advertisement
Table of Contents
