Edgemarc 250Ae Back Panel - Edgewater Networks EdgeMarc 250AE Hardware Installation Manual

EdgeMarc 250AE Hardware Installation Guide

EdgeMarc 250AE Back Panel

Figure 1-2
Figure 1-2 EdgeMarc 250AE Back Panel Components
Table 1-2
Table 1-2 EdgeMarc 250AE Back Panel Components
# Label
1 Phone
2 DSL/Line
3 Ethernet WAN xDSL port Connects the EdgeMarc to a cable or xDSL modem.
4 Ethernet LAN
5 USB
6 Erase
7 Power
6
shows the back view of the EdgeMarc 250AE.
defines the EdgeMarc 250AE back panel components.
Function Description
FXS ports (4) 10/100/1000 Mbps RJ-45 Ethernet FXS ports for
connecting IP phones. Default IP: 192.168.1.1
FXO port Connects the EdgeMarc to a phone line supporting
ADSL/ADSL 2/2+ standards. The FXO feature can be used
to make calls to the PSTN.
Note: Your connection to the PSTN can be tested by
attaching a phone to FXS port 4 and disconnecting the
EdgeMarc from the power source.
LAN ports (8) 10/100/1000 Mbps RJ-45 Ethernet ports for LAN
network connectivity. Default IP: 192.168.1.1.
Note: The EdgeMarc can also be configured through any of
these ports using the web interface.
USB port (1) USB port.
Erase Press the Erase button in quick succession to control the
button following:
• One click—No action.
• Two clicks—Resets the CLI and GUI password with no
service interruption.
• Three clicks—Restores to factory default settings and
reboots the system.
Note: When restored to factory default settings, the
current configuration is lost, disconnecting all VoIP devices,
Internet connectivity, and network access for computers
until the system is reconfigured.
Input Connects the EdgeMarc to an AC power outlet.
Power
Socket
© 2014 Edgewater Networks. All Rights Reserved.