Installing The Edgemarc On A Desktop, Shelf, Or Tray; Wall Mounting The Edgemarc - Edgewater Networks EdgeMarc 250AE Hardware Installation Manual

for static electricity to follow and safely dissipate into the ground.The
grounding impedance to ground must not exceed 0.5 ohm. It is
recommended that a minimum 14AWG be used to ground the unit. Contact
the appropriate electrical inspection authority or an electrician if you are
uncertain that suitable grounding is available or the local applicable
standard.
Installing the EdgeMarc on a Desktop, Shelf,
or Tray
1.
2.
3.

Wall Mounting the EdgeMarc

You can mount the EdgeMarc 250AE appliance on a wall using the two
mounting holes on the bottom of the chassis. You will need two screws to
mount the EdgeMarc chassis to the wall and optionally, two hollow wall
anchors. Refer to
Figure 2-3
1.
2.
© 2014 Edgewater Networks. All Rights Reserved.
Remove the EdgeMarc and accessories from the shipping container.
Place the device on a flat, dry surface such as a desktop, shelf, or tray.
Connect the EdgeMarc to ground. Refer to
Figure
Screw Specifications
Install two screws 5.9063 (150 mm) horizontally apart on a wall or
other vertical surface. The screws should protrude from the wall so that
you can fit the appliance between the head of the screw and the wall.
If you install the screws in drywall, use hollow wall anchors to ensure
that the unit does not pull away from the wall due to prolonged strain
from the cable and power connectors.
Mount the EdgeMarc horizontally on the wall with the ports facing
upwards.
2-3.
Physical Installation
Grounding the EdgeMarc.
9