Table of Contents
Advertisement
Cougar Video
2.13 32X32 Video Matrix Card Installation
2.14 Rear Panel Connectors
2
INSTALLATION
page 2.12
Installation
The 32X32 Video Matrix Card is installed in the lower portion of the Cou-
gar Video Routing Switcher. To install the matrix board in the Cougar
Video Routing Switcher take the following steps while referring to the
Cougar Video Mainframe configuration drawing on page 6.2:
1. Align the shield plate of the matrix card with the set of circuit card
guides in the lower portion of the Cougar Video Routing Switcher.
2. Carefully push the matrix board into the switcher until the circuit card
connectors make initial contact with backplane connectors. At this
point, firmly but carefully continue pushing the matrix card into the
switcher while making sure the connectors are properly aligned. Con-
tinue pushing the card until it is in place and the connectors are firmly
mated.
The manual subsections discuss the various system connectors found on
the rear backplane (rear panel) of the Cougar Video Routing Switcher.
Refer to the 32X32 Video Backplane component assembly drawing on
page 6.4 and to Figure 2-8 for a visual references.
Figure 2-8 Cougar Video Routing Switcher Rear View
RCP Panel Connectors (J9-J12)
The RS485 panel port connectors allow the daisy-chained connection of
up to 64 remote control panels to the Cougar Video Routing Switcher.
Bidirectional communications between the internally installed System
Controller(s) and the various models of PESA's low cost RCP control
panels are sent and received over RS485 buss.
Section 2
11/97
P/N 81905903420
Advertisement
Table of Contents
