Level Code (Strobe) Selection; Figure 2-2 Cables Attached To Supports; Figure 2-3 Level Code Selection - PESA
Cougar Video Introduction Manual

Cougar Video
2.6 Cabling Continued:

2.7 Level Code (Strobe) Selection

2
INSTALLATION
page 2.4
Installation

Figure 2-2 Cables Attached to Supports

The level (strobe) select switch, S3, (a binary coded switch) is located on
the inside of the Cougar Video Routing Switcher on lower left-hand side of
the backplane. Switch numbers are 1 through 8 right to left. Switches 1-6
select level codes 0 through 62. Switches 7 and 8 are not used – their
position is unimportant. Refer to Figure 2-3 for an example of level code
selection and see Figure 2-4 for the physical location of the level code
switch.

Figure 2-3 Level Code Selection

Section 2
11/97
P/N 81905903420