Table of Contents
Advertisement
Internal PS130 Power Supply Addendum
Front Door Installation (Removable Front Doors Only)
To install the PESA equipment item's front door (cover) take the following
steps:
1. Align the front door with the front of the PESA equipment item.
2. Once the front door is aligned with the front of the PESA equipment
item, slide the front door onto the equipment item until the slide locks
snap into the locking provided on the equipment item's chassis.
Power Supply Removal and Replacement
Two AC Power Cords may be connected to this unit.
Power Supply Removal
To remove the PESA equipment item's power supply or power supplies take the
following steps:
1. Disconnect the AC power cord connected to the power supply to be
removed.
2. Remove or open the equipment item's front door.
3. Grasp the power supply slide lock and pull it toward the center of the supply.
4. Once the slide lock is slid toward the center of the supply, carefully pull the
power supply out of the equipment chassis.
5. Repeat step 1 and steps 3 and 4 to remove any additional power supplies
from the equipment item.
Power Supply Installation
To install the PESA equipment item's power supply or power supplies take the
following steps:
1. Align the primary power supply with the primary set of power supply circuit
card guides in the equipment item's chassis.
page 4
*CAUTION*
Internal PS130 Power Supply Addendum
3/98
Advertisement
Table of Contents
