Table of Contents
Advertisement
Cougar Video
2.11 PS70V Power Supply Installation Continued:
2.12 16X16 Crosspoint Card Installation
2
INSTALLATION
page 2.10
Installation
3. Align the secondary (redundant) power supply with the right-hand set
of circuit card guides in the upper right-hand side of the Cougar Video
Routing Switcher.
4. Repeat step two.
5. If the Cougar Video Routing Switcher is being shipped, install the two
power supply retainer screws through the top of the Cougar Video
Routing Switcher.
Up to four 16X16 Crosspoint Cards can be installed on each 32X32 Video
Matrix Card. For the inputs and outputs controlled by each crosspoint card
refer to Figure 2-7. To install the crosspoint cards on the 32X32 Video
Matrix Card take the following steps while referring to the Cougar Video
Mainframe configuration drawing on page 6.2:
1. Place the video matrix card on solid flat surface.
2. Align the connectors on the lower side (connectors are along the left,
right, and top sides) of the 16X16 Crosspoint Card with a set of cross-
point connectors on the right-hand side of the 32X32 Video Matrix
Card. Make sure the orientation of the 16X16 Crosspoint Card is
correct.
3. Carefully mate the connectors on the 16X16 Crosspoint Card with the
selected set of connectors on the 32X32 Video Matrix Card. As the
connectors are being mated make sure no connector pins are bent or
misaligned.
4. Carefully but firmly push the 16X16 Crosspoint Card down until the
connectors on the 16X16 Crosspoint Card are firmly mated with the
selected set of connectors on the 32X32 Video Matrix Card.
5. Repeat steps 1-3 until all of the 16X16 Crosspoint Cards are installed
on the 32X32 Video Matrix Card.
Section 2
11/97
P/N 81905903420
Advertisement
Table of Contents
