Table of Contents
Advertisement
Setting Auto Initialize
¦
When you clone settings from one TV to another, you clone both the guest side menu and hospital side menu settings:
Picture, Sound, Input, Channel, Setup, and Hospital Setup. This lets you set nearly all the menu values on your hospitality
TVs to the same, standard settings. If you allow guests access to the guest side menus, for example - the Picture menu -
they can change the settings in those menus so they are no longer standard. If you set the Setting Auto Initialize function
to On, the TV automatically restores (initializes) any guest-side menu values to the cloned, standard values when the TV is
turned off and then turned on again. Note that Setting Auto Initialize works on cloned guest side menu values only. Settings
which have not been cloned are ignored.
The table below lists the settings that are restored to their cloned values when you set the Setting Auto Initialize function to
On.
Menu
Picture Mode
Backlight
Contrast
Brightness
Sharpness
Color
Tint (G/R)
Picture Size
PIP
Advanced Settings
Picture Menu
Picture Option
Picture Off
Reset Picture
[HG673-ZA]Install Guide-ENG.indd 23
Menu Item
Picture Size
Position
Dynamic Contrast
Black Tone
Flesh Tone
RGB Only Mode
Color Space
White Balance
Gamma
Motion Lighting
Color Tone
Digital Clean View
MPEG Noise Filter
HDMI Black Level
Film Mode
LED Clear Motion
Menu
Sound Mode
Sound Effect
DTS TruSurround
DTS TruDialog
Equalizer
Speaker Settings
Sound Menu
Speaker Select
Auto Volume
Digital Audio Out
Audio Format
Audio Delay
Reset Sound
Setup
Menu Language
Time
Clock
Sleep Timer
On Timer
Off Timer
Eco Solution
Energy Saving
System Menu
Eco Sensor
No Signal Power Off
Auto Power Off
Auto Protection Time
Change PIN
General
Game Mode
Boot Logo
DivX® Video On Demand
Menu Item
23
English
2013-03-07
10:59:36
Advertisement
Table of Contents
