To Enter this menu: Press the
To exit from this menu : Power Off (or Power Off and unplug if you have changed SI Vendor), and then turn on again. Any
changes you made are saved.
[HG673-ZA]Install Guide-ENG.indd 13
→ ENTERE buttons in order.
Select Hospitality mode.
Interactive mode : Samsung / MTI / TELEHEALTH / Innvue.
Stand-alone mode : OFF, SSCP
Interactive mode : Samsung / OCC / MTI / Nstreams / NXTV / Enseo / Cardinal /
Guestek / Seachange / EBL
Stand-alone mode : OFF / Smoovie
Set the default values that will be applied when the TV is turned on.
User Defined : Lets you set Power On Channel and Channel Type manually. See
Power On Channel and Channel Type below.
Last Saved : If you select this item, when the TV is turned on, it displays the channel it
was displaying when it was turned off.
When the TV is turned on, it switches automatically to this channel.
Select channel band : AIR (analog air band), DTV (digital air band), CATV (analog cable
band), CDTV (digital cable band).
User Defined : Lets you set the Power On Volume manually. See Power On Volume
Last Saved : When the TV is turned on, it returns to the volume that had been set
when the power had been turned off.
The TV turns on with this Volume Level in Stand Alone Hospitality mode.
The minimum Volume Level the user can set in Stand Alone Hospitality mode.
The maximum Volume Level the user in Stand Alone Hospitality mode.
Turning the front panel (local key) operations on/off.
Unlock : Unlocks all panel keys.
Lock : Locks all panel keys.
Power : Locks all panel buttons except Power.
Menu/Source : Locks the Menu and Source.
Select the input source the TV displays when turns on.
Determines the TV's state when power returns after a power failure or after you have unplugged
the TV and then plugged it in again.
LAST OPT : Returns to its last Power state. If it was in Stand-by, it returns to Stand-
by. If it was on, it turns on.
Power On : When the power returns, the TV turns on.
Standby : When the power returns, the TV enters the Standby mode.
The Channel Editor lets you edit the channels stored in the TV's memory. Using Channel Editor
Change the channel numbers and names, and sort the channels in your desired
channel number order.
Apply the video mute to channels you select. The video mute blanks out the video
from a channel and outputs only the sound while displaying a speaker icon on the
The Channel Editor also lets you view information about each channel easily, without your having
to display each channel directly.
Lets you edit the channel bank that works with the item of Channel Bank Service Level or the
Smoovie Remote. See page 27.
Set the limitation of access to the TV channels that the patient (or the guest) can watch with this
item. See page 27.
Normal: All the channels available on the TV are accessible to the patient.
Bank1/2/3: Only the channels assigned to the selected channel bank in the Channel
Bank Editor are accessible to the patient.
None: Channels cannot be changed by the patient. (The patient can watch only one
channel set when TV is turned on.)
On : Check the DTV Program channel number. (DTV channel editor is inaccessible)
Off : No check of the DTV Program channel number. (DTV channel editor is
accessible, but additional channel program number update is not supported)
Gives you direct, immediate access to Auto Program for searching channels.