Table of Contents
Advertisement
Searching single service of a transponder
Searching every service of SMATV system
will become enabled. You also should set these options
correctly.
NOTE
You may get transponder information from a satellite maga-
zine or website such as
//www.lyngsat.com.
To search single service of a transponder, take the following
steps:
1. Choose your desired satellite at the Satellite Name op-
tion.
2. Set the Search Mode option to Advanced, and then press
£
¢ ¡
the
button to diaply additional options.
OK
3. Choose your desired transponder at the Frequency op-
tion or enter it with the numeric buttons.
4. Enter the symbol rate of your desired transponder to the
Symbol Rate option with the numeric buttons.
5. Set the Polarization option to match to that of your de-
sired transponder.
6. Set the Modulation option to match to that of your de-
sired transponder. If the transponder is of the DVB-S2
standard, you should set this option to DVB-S2 QPSK or
DVB-S2 8PSK. Then the FEC option and the Pilot option
will become enabled. You also should set these options
correctly.
7. At the PID option, specify the audio and video packet
identification (PID) of your desired service with the nu-
meric buttons.
To search every service of a SMATV system, if the digital re-
ceiver is connected to it, take the following steps:
3.1 Searching for broadcasting services 23
http://www.satbeams.com
http:
or
Advertisement
Table of Contents
