Table of Contents
Advertisement
22 Service Search
Searching every service of a transponder
1. Choose your desired satellite at the Satellite Name op-
tion.
2. Set the Search Mode option to Auto.
3. If you set the Network Search option to On, the digital
receiver will check up the up-to-date channel informa-
tion while searching services, but it takes a rather longer
time.
With the Auto mode, the digital receiver tries to search every
service, relying on the transponder data which is stored at the
time of manufacture. It thus may happen to fail to search all ac-
tually available services since services are more often than not
launched, discontinued, or removed into another transponder.
To search every service of a transponder, take the following
steps:
1. Choose your desired satellite at the Satellite Name op-
tion.
2. Set the Search Mode option to Manual, and then press
£
¢ ¡
the
button to diaply additional options.
OK
3. Choose your desired transponder at the Frequency op-
tion or enter it with the numeric buttons.
4. Enter the symbol rate of your desired transponder to the
Symbol Rate option with the numeric buttons.
5. Set the Polarization option to match to that of your de-
sired transponder.
6. If you set the Network Search option to On, the digital re-
ceiver will check up the up-to-date channel information
as searching services, but it takes rather longer time.
7. Set the Modulation option to match to that of your de-
sired transponder. If the transponder is of the DVB-S2
standard, you should set this option to DVB-S2 QPSK or
DVB-S2 8PSK. Then the FEC option and the Pilot option
Advertisement
Table of Contents
