Advertisement
User Instructions
To alter the temperature that the thermostat controls at simply turn
the setting dial on the thermostat. As the setting dial is moved the
small LCD display will show the selected temperature.
Once the required temperature is set, the LCD display will show the
temperature of the water in the cylinder close to the position where
the sensor is located.
A small "Flame
"
icon is lit in the display whenever the thermostat is
calling for heat. Please note that the boiler will only run when both
the thermostat and the time control are calling.
The CET B-RF is battery powered. Baneries will last in excess of
two
years. A'Banery" icon will flash in the display when baneries need to
be changed. To change the batteries loosen the two screws on the
base of the thermostat and lift thermostat off base plate. Batteries
are located in the rear of the thermostat unit and should be replaced
using two high quality AA size alkaline cells.
Danfoss Randall Ltd
Arnplh~ll Road, Bedford MK42 9ER
Tel 01234 364621
Fax 01234 219705
Ernall danfossrandalI@danfoss corn
Webslle www danfoss-randall co
uk
1 .
l o w '*lIag~
D#rect#vp
1
3
8 ,
'.
,
Part
No 25317 Iss.1 03/04
Advertisement
