Active Infitec; Communication; Network Connections - Barco Galaxy NH-12 User Manual

See the Display setup menu (for the stereo output and system settings) and the Image menu (for the stereo
input settings)
4.5.11 Active Infitec
The Active Infitec
How to connect when using active Inftitec
1. The input connection is done in the same way as described above but the stereo output signal is not required in this case since
Infitec stereo glasses are required instead (these glasses are passive i.e. not switched).
TM

4.5.12 Communication

Overview
•

Network connections

• Network settings
• RS232 communication
4.5.12.1 Network connections
What can be done ?
The projector can be connected to a network allowing it to be accessed from any connected network device. The Ethernet connection
can be used to upload/download projector software and/or to set up communication (TCP-packets) with the projector. This network
can be a local area network or a small dedicated network
Following operations are made possible :
• file transfer for firmware upgrade
• easy adjustment of projector
• storage of multiple projector configurations and set ups.
• wide range of control possibilities.
• linking the projectors to allow uniform color (Linked Dynacolor) and brightness (CLO) ,...
• ...
The connection to the projector can be done via a crossed cable or via a HUB on the local network (LAN).
The Ethernet connection is also used to allow the Desktop integration. The software on the delivered CDROM
must therefore be installed on the desktop PC. See the Desktop integration software User Guide.
How to connect the projector ?
1. Connect the RJ 45 male plug to the projector's RJ 45 female connector
R59770122 BARCO GALAXY NH-12 04/05/2011
TM
feature is optional: a software key is needed to activate it.
TM
stereo ?
TM
4. Installation
31