4076-0XX
SIMM Problem
SYMPTOM
Can't write to SIMM
Service Checks
Envelope Feed Service Check
FRU OR PROCEDURE
1
Envelope Loading
First Print Line Service Check
FRU OR PROCEDURE
1
End-of-Forms Flag
2
End-of-Forms Sensor
3
System Board
4
Feed Arm Assembly
5
Software Setting
6
Operator Panel
ACTION
Go to the
"Simm Service Check" on
page
22.
ACTION
Be sure the envelope guides have
been turned to the envelope load
positions
Be sure the envelope guides are
against the envelopes
Go to and perform the
Service Check" on page
ACTION
Check the flag for binds or damage.
Check the sensor for dirt.
Perform the
"Paper Sensor Test" on
page 26
to check the end-of-forms sen-
sor.
Check all parts of the feed arm assem-
bly for binds, wear, or damage.
Use Toolkit, on the setup diskette, to
adjust the Top of Form setting.
Go to the
" Note: if the failure remains,
replace the system board" on page
Diagnostic Information
"Paper Feed
14.
12.
11