Advertisement
B: To power the antenna with extra power adaptor
1. Use this installation if your Digital Terrestrial Receiver does not support an active antenna.
2. Connect the supplied power adaptor to the "DC IN" connector on the back of the antenna.
3. Proceed with positioning the antenna as described above in section A (points 3, 4, 5).
NOTE:
The antenna will not function properly if the built-in amplifier is not powered.
Therefore it is required to supply the antenna with power via the coaxial cable or via
an external adapter.
Extension of the coaxial cable:
In some cases you may need to extend the standard supplied coaxial cable, we advise you to only do so
if you cannot get optimal signal strength within the reach of the standard cable. If you are to extend the
coaxial cable, then please note following comments:
Use a good quality coaxial cable, 75 Ohm type only with proper shielding
„
„
Use well shielded connectors, your dealer can advise you on this.
„
„
Make sure that both inner cable and shielding are properly connected to the connectors to
„
„
assure active antenna power supply and to avoid short circuit in the cable.
If you extend the cable, please keep the cable as short as strictly needed. Extending the cable or using bad
quality cable will reduce the performance of your antenna.
Subject to alterations. In consequence of continuous research and development technical specifications, design and appearance of products may change. All
product names are trademarks or registered trademarks of their respective owners.
© STRONG 2012. All rights reserved.
4
PART 1
Advertisement
