Understanding the parts of the printer
Use the
1
2
3
4
PictBridge port
5
Card reader light
6
Memory card slots Insert a memory card. For more information on what types of memory cards can be
11
10
9
8
7
6
To
•
Turn the printer on and off.
– If the printer is inactive for 30 minutes, the printer reverts to sleep mode to conserve
energy. Press
or start a print job to turn the printer back on.
– When the printer is in sleep mode, pressing and holding
turn off the printer.
•
Cancel a print job. Press
•
Be alerted for errors. For more information, see "Power light is blinking" on
page 69.
•
Load or eject paper.
•
Cancel a print job. Press
•
Print on both sides of the paper (duplex). A green backlight comes on when the
duplex function is activated.
Note: This button is not functional with a Macintosh operating system. You can print
two-sided documents with a Macintosh operating system by using the settings in the
Two-Sided menu of the Print dialog.
•
Be alerted for errors. For more information, see "Duplex light is blinking" on
page 70 and "Power light and duplex light are blinking alternately" on page 70.
Connect a PictBridge-enabled digital camera or a flash drive to the printer.
Check card reader status. The light blinks to indicate a memory card is being accessed.
inserted into each slot, see "Inserting a memory card" on page 31.
Understanding the printer
12
W
I
P
R
F
IN
T IN
I
G
4
5
in the middle of a print job.
in the middle of a print job.
45
1
2
3
for two seconds will