Fujitsu AOU48RLXFZ1 Installation Manual page 29

(1) Setting method
Use the MODE/EXIT, SELECT, and ENTER buttons to configure settings according to the procedures below.
1: Function Setting
First 2 digits Last 2 digits
MODE/EXIT
(Blinking)
SELECT
(Blinking)
ENTER
2: Setting the
first 2 digits
(Blinking)
SELECT
Every press of the "SELECT"
button will change the setting
number for the first 2 digits.
(Blinking)
SELECT
(Blinking)
MODE/EXIT
SELECT
(Press the MODE/EXIT button to cancel the setting mode.)
EXIT
7 seg. display
(When [F3] to [F9] are displayed, continue to press
the SELECT button until [F2] is displayed.)
ENTER
(Blinking)
ENTER
MODE/EXIT
: Press the "MODE/EXIT" button.
: Press the "SELECT" button.
SELECT
: Press the "ENTER" button.
ENTER
SELECT
(Continue to press the SELECT button until the
desired number appears at the last 2 digits.)
SELECT
(Blinking)
Setting is complete when the lamp lights up
Press "ENTER" button to return to "2.Setting the first 2 digits"
(If there is no operation for 5 seconds after the setting, the
display will return to "2: Setting the first 2 digits".)
SELECT
(Continue to press the SELECT button until the
desired number appears at the last 2 digits.)
SELECT
(Blinking)
Setting is complete when the lamp lights up
Press "ENTER" button to return to "2.Setting the first 2 digits"
(If there is no operation for 5 seconds after the setting,
the display will return to "2: Setting the first 2 digits".)
3: Setting the
last 2 digits
SELECT
(Blinking)
ENTER
(Press the ENTER button for more
than 3 seconds.)
(Blinking)
ENTER
(Press the ENTER button for
more than 3 seconds.)
En-29