Advertisement
Notice before assembly
The following tools are needed for assembly. You must buy them from the local hobby
shops apart from the kits we provided.
Please read and comprehend this instruction manual before assembly.
2-Channel Transmitter system
Please read the transmitter system instructions carefully before use.
The servo must be set at the center position before installation. To set the servo to neutral
position, turn on the transmitter and receiver, and sett the servo rod at the center position,
and then turn off the receiver and the transmitter in succession. The servo will be at the
proper position.
Antenna
Battery Indicator
LCD Plug
Power Switch
Charging Plug
Transmitter
Item No.:30133
Steering Trimmer
Throttle Trimmer
Battery Switch
Steering trigger
Throttle trigger
Steering Reverse
Throttle Reverse
Steering Wheel
Steering trigger
Speed controller
Throttle servo
Battery Case
-1-
Tools needed for assembly
1.5m/m
2m/m
2.5m/m
Hexagonal wrenches
Super
Glue
Receiver
Additional items needed to buy for
running in the engine
Steering servo
15%-30%
Fuel
Hobby Knife
Scissor
Cross Sleeve
Needle
Slide Cutter
Nose Pliers Cross Screw
Driver (No.2)
Charger
Ignition
Differential
oil
Fuel pump Air filter
Shock
oil
absorber oil
Cross Screw
Driver (No.1)
Advertisement
