Table of Contents
Advertisement
12.0
MAINTENANCE
ALWAYS DISCONNECT THE APPLIANCE AT THE SUPPLY OUTLET SOCKET BEFORE UNDER-
TAKING ANY MAINTENANCE.
Excluding the lamp and fuse, use only genuine spare parts available from your supplier.
Replacement lamps must be of the same wattage and specification as those stated in Section 2.0
Appliance Data/Specifications.
Replacing the Light Bulb.
1. Switch off at the appliance, and then disconnect the
plug from the outlet socket.
2. Remove the decorative front frame, and the lower
lamp cover plate (2 x screws), as described in section
8.0 to gain access to the bulb. Note: the fuel bed can
be removed if necessary to aid replacement.
3. The bulb has a conventional bayonet fitting.
Remove and replace with the new bulb (see Fig 5
opposite).
4. Reposition the lower lamp cover plate and replace the two No 8 Pozi screws, and tighten fully.
5. Reposition the decorative front frame and re-tighten the two lower frame fixing bolts.
6. Re-connect electrical supply and check for correct operation of the lamp and spinner assem-
bly.
13.0
CLEANING
ALWAYS DISCONNECT THE APPLIANCE AT THE SUPPLY OUTLET SOCKET BEFORE UNDER-
TAKING ANY CLEANING.
There are no specific requirements for care, other than regular cleaning of the general appliance.
A wipe with a dry cloth is normally sufficient.
DO NOT use abrasive cleaners as they can damage the finish.
STAINLESS STEEL AREAS - These parts may be cleaned using an appropriate metal polish. Clean
only in the direction of the grain. Alternatively, a small amount of baby oil applied in the direc-
tion of the grain, with a soft, lint free cloth. Another effective way to restore the 'as new' look to
the stainless steel parts, is use of a proprietary car interior cleaning agent such as 'Cockpit shine'.
This should be sprayed directly on to the metal and then wiped off with a clean lint free cloth.
14.0
SERVICING
There are no internal user serviceable parts.
Check regularly for security of wall fixings as appropriate. Also check security of supply cable
and connections. If the supply cable becomes damaged, it must be replaced by a service agent
or competent person, such as a qualified electrician.
The wires in the cable are coloured in accordance with the following code:
LIVE
NEUTRAL
EARTH
Refer to Section 2.0, Appliance Data for fuse specification. Excluding fuses and lamps, use only
genuine manufacturers spare parts available from your supplier.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your
local authority or retailer for recycling advice
As our policy is one of continuous improvement and development, we hope therefore you will understand we must retain the right to amend
details and/or specifications without prior notice.
- Brown
- Blue
- Green/Yellow
6
Fig 5
©
2009 Focal Point Fires plc.
Advertisement
Table of Contents
