Summary of Contents for Ekofires eko 1010
- Page 1 All instructions must be handed to user for safekeeping Revision A - 06/09 Country(s) of destination - GB/IE eko 1010 electric wall heater...
- Page 2 Tel: 01202 588 638 Fax: 01202 588 639 www.ekofires.co.uk e-mail: sales@ekofires.co.uk Please note : Except where otherwise stated, all rights, including copyright in the text, images and layout of this book- let is owned by Focal Point Fires plc. You are not permitted to copy or adapt any of the content without the prior writ- ten permission of Focal Point Fires plc.
-
Page 3: Table Of Contents
14.0 Servicing PRELIMINARY NOTES The eko 1010 electric wall heater provides convected heating in conjunction with a visual fuel effect display. The appliance is designed for indoor use, and can be simply wall mounted in the majority of wall posi- tions anticipated. -
Page 4: Site Requirements
SITE REQUIREMENTS The appliance is designed to be wall mounted via the brackets on the rear panel with the fixings provided. The wall should be relatively flat and not interfere with any of the ventilation slots in the rear panel. The wall must be structurally sound and of a material capable of withstanding moderate heat. -
Page 5: Unpacking The Appliance
UNPACKING THE APPLIANCE Caution: This appliance is heavy. Always seek assistance whilst unpacking and/or during installation. Read all the instructions before continuing to unpack or install this appliance. Carefully remove the appliance from its packaging and lay on the floor with it`s back surface downward. Note: DO NOT stand the appliance on its front frame as this may cause distortion. -
Page 6: 9.0 Fixing The Appliance
FIXING THE APPLIANCE A) Marking Positions: Having selected the final mounting position for the appliance, taking into account the site requirements as detailed in section 4, the heater can now be fixed to the wall. There are three fixing positions, two upper “hanging” positions”, and one lower position on the backpanel located behind the fuel bed. -
Page 7: Operating The Appliance
10.0 OPERATING THE APPLIANCE Read All Instructions Before Use Check that the heater outlet grille, mounted at the top of the appliance, is not covered or obstructed in any way, and ensure the power to the fire is switched on. The appliance is con- trolled using four switches mounted at the right hand side towards the top. -
Page 8: 13.0 Cleaning
12.0 MAINTENANCE ALWAYS DISCONNECT THE APPLIANCE AT THE SUPPLY OUTLET SOCKET BEFORE UNDER- TAKING ANY MAINTENANCE. Excluding the lamp and fuse, use only genuine spare parts available from your supplier. Replacement lamps must be of the same wattage and specification as those stated in Section 2.0 Appliance Data/Specifications.