Table of Contents
Advertisement
CONTENTS
1.0
2.0
Appliance Data/Specifications
3.0
4.0
5.0
6.0
7.0
1.0
PRELIMINARY NOTES
The eko 1010 electric wall heater provides convected heating in conjunction with a visual fuel
effect display.
The appliance is designed for indoor use, and can be simply wall mounted in the majority of wall posi-
tions anticipated. It can can be located in any household room, with the exception of bathrooms.
Read all of the instructions before commencing installation. Retain for future reference and pass on
as necessary to subsequent owners of the appliance.
DO NOT use this appliance immediately below a fixed socket outlet.
DO NOT use this appliance in the immediate vicinity of a bath, shower, swimming pool or other area
where water/moisture could present a hazard.
• CAUTION: This appliance must not be used in conjunction with any timer, programmer or thermal
control, or any other device that will switch on the appliance automatically, as a fire risk may occur
if the heater is accidentally covered or displaced.
• Do not allow the heater to be covered as this may cause overheating. The appliance must not be
placed near curtains or similar material. A clearance space of at least one metre should be allowed
in front of the appliance.
• The electrical socket that the appliance uses MUST be easily accessible. Do not route the supply
cord directly in front of the heater unit.
• If the cord is damaged, it must be replaced by a service agent or competent person.
• This appliance is not intended for use by persons (including children) with reduced physical, sen-
sory or mental capabilities, or lack of experience and knowledge, unless they have been given super
vision or instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
2.0
APPLIANCE DATA
Weight (kg):
Dimensions (mm):
Voltage (Volts):
Heating Elements:
Supply Cord:
Supply Plug:
Location:
Lighting:
3.0
ELECTRICAL INSTALLATION REQUIREMENTS
The appliance is designed to be wall mounted using the brackets and fixings provided.
DO NOT RECESS ANY PART OF THE APPLIANCE.
The appliance is supplied with a pre-wired three pin BS1363 plug (13 Amp fuse rated), and 2 metre
cable. A standard switched outlet/wall socket, (including earth provision), must therefore be located
within this distance, and be easily accessible in order to isolate the supply for maintenance and clean-
ing. This socket must not be mounted behind or above the appliance.
IMPORTANT: THIS APPLIANCE MUST BE EARTHED.
Page No.
Section Contents
1
8.0
1
9.0
2
2
12.0 Maintenance - Lamp Replacement
3
3
10.0KG
H 585 x W 500 x D 133
230-240V a.c. 50Hz
2 x 900/1000 Watts
2 metres
BS 1363, 13A Fused
Indoor Use
1 x 60W Amber B.C. Bulb
1
Page No.
3
4
5
5
6
6
6
©
2009 Focal Point Fires plc.
Advertisement
Table of Contents
