Unpacking The Appliance; Component Checklist; 8.0 Preparing The Appliance - Ekofires eko 1010 Installation And User Instructions Manual

6.0

UNPACKING THE APPLIANCE

Caution: This appliance is heavy. Always seek assistance whilst unpacking and/or during
installation.
Read all the instructions before continuing to unpack or install this appliance. Carefully remove
the appliance from its packaging and lay on the floor with it`s back surface downward.
Note: DO NOT stand the appliance on its front frame as this may cause distortion.
Check that the remaining packaging contents correlate with the component checklist below.
Please dispose of all packaging with care at your local recycling centre.

COMPONENT CHECKLIST

7.0
QUANTITY
1
1
1
3
3
1
8.0 PREPARING THE APPLIANCE
DO NOT connect the appliance to the supply at this stage.
1. Carefully remove the front decorative frame from the main casing by
unscrewing and removing the 2 lower M6 fixing bolts, (2 locat-
ed on either side), as shown in Fig 2.
2. Lift the frame vertically upwards to clear the upper two fixing
bolts and pull gently forwards to release from the main case assembly.
3. Now remove the 2 x No 8 Pozi self tapping
screws, retaining the lower lamp cover plate, as
shown in Fig. 3, and remove the cover plate.
4. Carefully "ease" the white fuel bed from the appliance.
This allows access to the lower fixing position located at the
back of the main case assembly. See Fig 4.
DESCRIPTION
Fire Appliance and Decorative Frame
Bag of Decorative Pebbles
Instruction Booklet
37mm long round head screws
Wall plugs
Wall Mounting Template
Lower fixing
position
3
Upper
Fixings
Lower
Fixings
Lamp cover
plate
©
Fig 2
No 8 fixing
screws
Fig 3
Fig 4
2009 Focal Point Fires plc.