Remove/Install The Bendix\King Klx 135/135A Gps Comm - Diamond DA20-C1 Maintenance Manual

DA20-C1 AMM
3.

Remove/Install the Bendix\King KLX 135/135A GPS COMM

A. Remove the Bendix\King KLX 135/135A GPS COMM
1. Open the related GPS COMM circuit-breaker.
2. Put a 3/32 allen wrench into the access hole for
the locking screw. Engage the screw.
3. Turn the screw counter-clockwise until the unit
disengages from the mounting rack.
CAUTION:
CAUTION:
4. Pull gently on the sides of the unit to remove it
from the mounting rack.
5. Install the protective covers on the rear
connectors of the unit.
B. Install the Bendix\King KLX 135/135A GPS COMM
1. Remove the protective covers from the
connectors on the rear of the unit.
2. Slide the unit into the rack. Engage the locking
screw so that the latch front lobe touches the
rack.
3. Turn the locking screw clockwise so that the
rear lobe engages the mounting rack.
CAUTION:
4. Continue to turn the screw until the unit is fully
installed in the mounting rack.
5. Close the GPS COMM circuit-breaker.
6. Do a function test.
DA201-C1
Rev 16
Detail Steps/Work Items
DO NOT PULL ON THE KNOBS. DO NOT PRY THE FACE-PLATE.
YOU CAN DAMAGE THE UNIT.
DO NOT TOUCH THE CONNECTOR CARD AT THE REAR OF THE
UNIT. THE ELECTROSTATIC CHARGE ON YOUR BODY CAN
DAMAGE THE UNIT.
Detail Steps/Work Items
DO NOT OVER-TIGHTEN THE LOCKING SCREW. YOU CAN
DAMAGE THE LOCKING MECHANISM.
23-10-00
Key Items/References
Refer to Figure 3 in Chapter 23-10.
Key Items/References
Refer to Figure 3 in Chapter 23-10.
See below.
Maintenance Practices
Page 203
30 Oct 09