Lexicon PCM 80 User Manual page 57

Press Load/ to bring up the Values display. The last value edited will be
displayed, so you will see either the minimum or maximum value.
Patch 1 Values
000 +0 MONO
If the is not at the left of the Source value, press Load/
it there. (You can take a short cut instead — simultaneously press Down and
Load/ to back-step.)
Patch 1 Values
000 +0 MONO
Turn ADJUST to display 64. This will be the Source value of our new pivot point.
The string of dots in the destination value portion of the display indicate that there
is no Destination value assigned when the source value is 64.
Press Load/ to move the
clockwise to set the Destination value for this point to –45.
By adding this pivot point, we have put a "kink" in the patch. The value of the
Destination parameter no longer moves in a straight line between 0 and 90.
Instead it moves from 0 to –45, and then from –45 to 90. This will produce a very
different sounding spatial change from the original patch. You can see the
difference by pressing Load/
pressing Edit to jump back to the Destination parameter to watch its value
change.
Patch 1
OR
127 :
Patch 1
OR
Patch 1 Values
064 : . . . . . . . . . . . . . .
to the right of the Source value, and turn ADJUST
Patch 1 Values
064 : -45 R, L
twice to display the patch Destination, then
Values
+90 L-R, R-L
three times to move
Values
127 : +90 L-R, R-L
Basic Operation
2-39