Lexicon PCM 80 User Manual page 56

PCM 80 User Guide
Adding an additional pivot
point to the patch
2-38
So far, our example uses only two pairs of patch values. The Destination
parameter moves linearly between the value assigned at 000 and the value
asssigned at 127.
You can watch this change by displaying the Destination parameter. Here's how
to jump directly to it from the patch:
Press Load/ repeatedly to return to the Patch 1 Destination selection display.
Press Edit to jump directly to the FX Width parameter in the Controls Row.
Controls
0.5
The FX Width value will be changing
from 0 to 90 and back again.
The display will change to show position 0.5 in the Controls Row. Note that the
value is changing continuously from 0 to 90 and back again. Notice also the small
square in the upper right corner of the display. This patch destination indicator
appears whenever a parameter has been assigned as a patch Destination in the
effect being edited.
Now let's return to the Patch row to add a pivot point to the effect.
Press Edit to jump back to the Patch row.
Patch 1 Dst
Controls FX Width
Patch Destination Indicator
FX Width
+0...90 MONO
Patch 1 Dst
Controls FX Width
Lexicon