System Out Of Range Warning Messages - McKesson TRUEresult Owner's Manual

TRUEresult Quality Assurance / Quality Control Manual
®
7. With Test Strip still in Meter, touch edge of Test Strip Sample Tip to sample
and hold. Allow blood to be drawn into Test Strip. Remove Test Strip from
sample when dashes appear across the Display. Meter is testing.
Note: If Meter does not show dashes in the Display soon after touching the
sample to the Sample Tip, release and discard the Test Strip. Repeat the
test with a new Test Strip and a new sample. If problem persists, see
Troubleshooting, Section 8.
8. After the test is finished, the blood glucose result is displayed.
9. Hold the Test Strip vial with the Test Strip pointing down. Press the Strip
Release Button to release and discard the Test Strip into the appropriate
container. The Meter turns off.
10. Record the result as required by your facility.
Note: If blood glucose test result is greater than 240 mg/dL and the Ketone Alert
is turned on, the Ketone Symbol appears in the Display with the result.
The Ketone Alert may be turned on or off during Set Up, Section 5.

System Out of Range Warning Messages

WARNING!
The TRUEresult System accurately reads blood glucose levels from
20 - 600 mg/dL.
If test result is less than 20 mg/dL, "Lo" appears in the Meter Display.
If the test result is greater than 600 mg/dL, "HI" appears in the Meter Display.
ALWAYS repeat the test to confirm low ("Lo") or high ("HI") results. If results
still display "Lo" or "HI", contact the Doctor or Diabetes Healthcare
Professional immediately.
31