Sanyo SHAKC64AGB Instruction Manual page 18

System Controller
(a) Zone registration using the remote controller
(RCS-TM80BG)
(Determination of central address)
In this case, after confi rming which indoor unit is con-
nected to the remote controller and that the air conditioner
in the OFF state, you set the central addresses one at a
time.
If the system has no remote controller, connect a remote
controller to the system temporarily. Then follow this pro-
cedure.
NOTE
The indoor unit address must already have been set before
performing zone registration. If necessary, refer to the Installa-
tion Manual supplied with the outdoor unit.
(1) Press the and
remote controller for more than 4 seconds.
(2) Do not press
(3) Once in this mode, the UNIT No., CODE No., No. of SET
DATA and
shown Fig. 3-63.
NOTE
In case of group control "ALL" instead of "UNIT No." will fl ash
on the display. Select the main indoor unit address by pressing
3
the button once.
(4) Set CODE No. to 03 using the
buttons.
NOTE
CODE No. 03 must be selected to perform zone registration
using the remote controller.
(5) Set the Central address which you want to assign to the
indoor unit address using the
according to the zone registration table.
(6) Press the button. The CODE No. and Central address
changes from fl ashing to ON state. If you make a mistake,
then press the
(7) Press the button to fi nish zone registration.
buttons at the same time of the
button.
indications will fl ash on the display as
and
and
button and reset the central address.
buttons
For example, in this case
Indoor unit address:1-8
Central address :
.
Fig. 3-63
17 (ZONE 2, GROUP 1)
Fig. 3-64