Sanyo SHAKC64AGB Instruction Manual page 19

System Controller
(b) Zone registration using the system controller (SHA-
KC64AGB)
In this case, you set all Central addresses by system
controller at once manually.
(1) Press the and
more than 4 seconds.
and CODE No. C1 will fl ash.
(2) After confi rming that CODE No. C1 is displayed, press the
button. Once in this mode, a change takes place as
shown in Fig. 3-65.
(3) Select the zone and group No. which you want to set with
and
set, press the button.
(4) Set the unit No. (Indoor unit address) with
buttons, according to the zone registration table.
R.C. No. ..........................
Indoor unit No..................
(5) Press the button.
GROUP No. turns ON and UNIT No. (Indoor unit address)
changes from fl ashing to ON state. UNIT No. is registered
to selected ZONE No. and GROUP No.
If you make a mistake, then press the
reselect the ZONE, GROUP and UNIT No.
(6) Register the other UNIT Nos. in the same way by follow-
ing steps (3) to (5).
(7) Finally, complete the registration by pressing the
ton.
fl ashes for a few minutes, then goes OFF.
(c) Automatic zone registration using the system con-
troller (SHA-KC64AGB)
(1) Press the and
more than 4 seconds.
and CODE No. C1 will fl ash.
(2) Select CODE. No. C2 by pressing
button and press the
C2 changes from fl ashing to ON state and automatic
zone registration will start.
(3) All registered GROUP Nos. will disappear.
(4) Central addresses will be assigned from small indoor unit
addresses to large addresses in numerical order auto-
matically.
After automatic zone registration is completed,
changes from fl ashing to OFF.
(5) If an error occurs "CHECK" starts fl ashing and zone reg-
istration fi nishes at this time. Press the
(6) Finally, complete automatic zone registration mode by
pressing the button.
fl ashes for a few minutes, then goes OFF.
buttons at the same time for
(GROUP) buttons. If already
and
button
button
button and
but-
buttons at the same time for
and
button.
button.
If data is
registered
the unit No.
is displayed.
For example, in the case at left
Zone 3, group No. 7
Unit No. (indoor unit address) 2-8
Unit No. 2-8 is registered to zone 3-group 7.
If no data is
registered
no number
is displayed.
Selected
group No. if
no data is
registered.
Fig. 3-65
Fig. 3-66
Fig. 3-67
3