How To Start Group Operation; To Start Group Operation - Sanyo SHAKC64AGB Instruction Manual

System Controller

How to Start Group Operation

To start group operation

2
1
9
8
Power Turn the power supply switch on more than 5 hours before starting operation.
1 Press the SELECT button and select GROUP.
2 Select the ZONE No. including the group to be operated by pressing ZONE button.
Select the GROUP No. to be operated by pressing GROUP select buttons
3
4 Press the ON button.
5 Set the operation mode by pressing the MODE button.
6 Set the desired temperature by pressing one of the temperature setting buttons
7 Set the desired fan speed by pressing the FAN SPEED button.
8 Set the airflow direction to a specific angle or sweep mode.
9
By pressing
Individual
Central 1
Central 2
Central 3
Central 4
Under Central/Individual settings other than listed above, "CENTRAL" is displayed.
AUTO Operation Depending on the difference between the temperature setting and the room temperature, heating and
cooling alternate automatically so that a uniform room temperature is maintained.
Stop Confirming the GROUP No. to be selected, press the OFF button.
NOTE
, select your desired setting.
: Controls with the remote controller are possible.
: Individual ON/OFF operation with the remote controller is inhibited.
: Individual ON/OFF, MODE, and Temp. setting operations with the remote controller are
inhibited.
: Individual MODE and Temp. setting operations with the remote controller are inhibited.
: Individual MODE operation with the remote controller is inhibited.
The fl ap setting can be performed only for units that have no remote controllers.
4
Stop
3
5
6
7
.
.
3