Address Switch Setting; Pcb Of The Control Unit; How To Reach The Pcb - Sanyo SHAKC64AGB Instruction Manual

System Controller

Address Switch Setting

3
Gap
Coin
To avoid an electric shock hazard,
DO NOT touch any terminal on the
WA R N I N G
Printed Circuit Board with a metal
rod, a screwdriver edge nor a bare
hand when power is supplied.
Gap
To Installers,
After installation and adjust-
ment, be sure to turn the
BACK UP switch ON.

How to reach the PCB

Remove the Machine screw on the bottom of the back case. When you open
up the decorative cover, you will see 2 notches under the control unit. Inset
a coin or other fl at object into these notches and pry off the back case. The
PCB on the back of the control unit is now visible.
.
All bits are set off
when shipped from
factory.

PCB of the control unit