How To Perform Zone Registration - Sanyo SHAKC64AGB Instruction Manual

System Controller

How to Perform Zone Registration

To operate the system controller properly, zone registration is required after
fi nishing the test run (and after setting all indoor unit addresses) using one of the
following methods.
(a) Zone registration using the remote controller (RCS-TM80BG)
Refer to page 3-80
(b) Zone registration using the system controller (SHA-KC64AGB)
Refer to page 3-81
(c) Automatic zone registration using the system controller (SHA-KC64AGB)
Refer to page 3-81
For methods (a) and (b), you should make a zone registration table manually
before performing the registration. Use the form on page 3-79 for this.
For method (c), zone registration is executed automatically, proceeding from
small indoor unit addresses and small central addresses to larger numbers in
numerical order. For example:
Central address
ZONE-group
Indoor unit address
NOTE
1. An indoor unit address is assigned to each indoor unit during automatic ad-
3
dress operation. Each indoor unit address combines an R.C. address and
indoor unit number as follows:
This address is displayed on remote controller for UNIT No. when the UNIT button
is pressed.
2. The central address represents the zone and group number. These addresses are
assigned in ascending numerical order.
1 2 3 4
1-1 1-2 1-3 1-4
1-1 1-2 2-1 2-2
1 1 : Indoor unit address (UNIT No.)
Indoor unit No.
Refrigerant circuit No. (R.C. address)
5 6
1-5 1-6
2-3 3-1
.