Set Scan Resolution; Scan An Original; File Naming Convention; Power Off The Scanner - Pandigital PhotoLink PANSCN04 User Manual

Set Scan Resolution

The default resolution is 600dpi.
1. To change to 300dpi, press the
2. The power indicator will light orange for 600dpi or green for 300dpi.

Scan an Original

1. If necessary, insert your photo into the plastic sheath (see page 5).
2. With the side to be scanned facing upward and in correct orientation, align the left edge of the photo
against the left edge of the feed slot, and then adjust the guide lever so that it is against the right side of
the photo.
3. Gently push the original into the feeding slot and let go when it begins to feed through the slot. The power indicator light
blinks while scanning.
When scanning is completed, the indicator light will continue to blink momentarily indicating that the scanner is processing the
image and storing the file onto the memory card.
CAUTION: Insert only one original at a time, and insert the next original only when the previous one is done and the
blinking has stopped, otherwise the scanner may malfunction.
Do not remove the memory card or disconnect the power supply while the indicators are blinking.
This scanner only supports output images in JPEG (.jpg) format, and the date/ time attribute will not be added.
For more information on how this scanner stores the scanned image files on the memory card, refer to "Orientation" on
page 6.
If the memory card is near full (lower than 1MB), the power indicator light blinks. Use another card or delete some files on it
if necessary.
CAUTION: Do not scan glossy photos in humid environments (humidity higher than 70% RH); the surface of the photo will
become sticky and may cause the scanner to jam.

File Naming Convention

The Scanner will automatically create a folder titled Photo1 on your memory card, which will hold the first 9999 scans. Then
Photo2
folder will be created for the next 9999 scans, and so on.
Each scanned image is given a file name with the prefix
are stored. For example,
There can be up to 99 folders (
blinks.

Power off the Scanner

After all originals are scanned, press and hold the power button for more than 2 seconds.
Now you can safely disconnect the power and remove the memory card from the scanner.
The scanner will automatically power off if it's left idle for 13 minutes.
A u t o m a t i c I m a g e C r o p p i n g
The scanner has a built-in cropping function that detects and crops dark edges of an original during the scan process (see
illustration below).
RESOLUTION
PD0001.jpg PD0002.jpg
, , etc.
Photo1..9 PD0001... PD9999
,
button before scanning.
PD
followed by a 4- digit sequential number in the order the images
) on a memory card. If exceeded, the Status/Card indicator light
7