Set Sleep Mode; Reset To Factory Defaults; System Information; Support Information - Pandigital Photo Mail PAN8008DW User Manual

2. Select the desired photo
Note: The actual procedure for sending photos to the DPF varies by mobile device manufacturer/model. Refer to your mobile
device User Guide for instructions.
During the photo transmission, "Photo Transmitting" appears on the DPF screen. When completed, the photo(s) will automatically be
displayed in single photo mode.
S e t S l e e p M o d e
The DPF will stay on until you power it off, however, to save power you can set it to automatically go into a sleep mode when left idle for a
specific amount of time.
HOME
1. On the screen, press

Set Sleep Mode

2. Select
OFF (default) = Power saver is 'disabled'; DPF will remain on until you power it off or change the sleep mode setting
2/4/8 Hours = The DPF will automatically go into sleep mode when left idle the specified amount of time
Done
3. Select .
R e s e t t o F a c t o r y D e f a u l t s
If you have changed function settings, using this feature will restore settings to the factory pre-set defaults.
HOME
1. On the screen, press
Reset to Factory Defaults  Yes
2. Select
S y s t e m I n f o r m a t i o n
You can check your system settings for your Photo Mail, internal memory, Wi-Fi, and firmware version. Also, you may be asked for specific
information found on this screen if you call customer support.
When an option is highlighted, a brief description and/or information appears on the screen in the lower white area.
HOME
1. On the screen, press
Setup Menu
2. On the
3. Use     to scroll through the options.
Frame Name: Identifying name, especially useful when you have multiple frames. To change name, see step 4.
User ID: Your email address used when registering your DPF (i.e., yourname@yahoo.com)
Photo Mail address: The email address that you will give to family & friends for sending you Photo Mail.
Available Internal Memory: Space that is available for importing photo, music, or video files
3G/EDGE: Connected to [wireless network]
Wi-Fi Network: Connected to [local Wi-Fi network]
Firmware: Current firmware version
4. To assign a custom Frame Name (i.e., Living Room, George-Office, etc.), use  to select
enter your desired custom name
S u p p o r t I n f o r m a t i o n
If you call Customer Support for help with Photo Mail issues, you will be asked for specific Photo Mail troubleshooting information listed on

Support Information

the
Follow these steps before calling Customer Support:
PHOTO MAIL
1. Press
EXIT
2. Press to return to the

send to the DPF.
MENU
to display the

the desired setting.
MENU
to display the
to reset, or
MENU
.

System Information

screen, select
Off = not connected
Examples: Wireless Network: Connected to ATT
IC CID: 8901650907000112615
IMEI: 354060011518152
Examples: IP Address: 192.168.1.95
Subnet Mask: 255.255.255.224
Default Gateway: 192.168.0.1
DNS Server: 192.168.1.2
 Done
(If you need help navigating the virtual keyboard, refer to
.
screen. Some of the information will not be listed until after you have connected with the Photo Mail server.
on the remote control, or select
HOME
screen.
Setup Menu
.
Setup Menu
.
No
to leave current settings.
.
Off = not connected
HOME
Photo Mail
on the

use the virtual keyboard to
The Virtual Keyboard
Photo Mail Inbox
screen to display the
on page 8.)
screen.
25