Disassembly And Assembly - Pride Mobility Victory Owner's Manual

V I I I . D I S A S S E M B LY A N D A S S E M B LY
The Victory requires no tools for disassembly. Always disassemble or assemble your scooter on a level, dry
surface with sufficient room for you to work and move around your scooter. Keep in mind that the disassembled
sections of the scooter will take up more floor space than the assembled scooter.
DISASSEMBLY
1. Remove the key from the key switch. See IV. “Your Scooter.”
2. Push down on the manual freewheel lever. See IV. “Your Scooter.” Putting your scooter in drive mode may
make it easier for you to maneuver the rear section because the drive wheels are stabilised.
3. Make certain that the seat is locked into position. See VII. “Comfort Adjustments.” Lift the seat up and off of
your scooter.
4. Gently lift the rear shroud off of your scooter.
The rear shroud is held in place with a reus-
able fastener.
5. Unplug both battery harnesses. See figure 13.
6. Loosen the battery straps, then lift both bat-
teries from the battery wells.
7. Unplug the large, white, 9-pin front-to-rear
harness that attaches the front control con-
sole module harness to the electronic con-
troller module harness. See figure 13.
WARNING! Failing to unplug both battery harnesses and the front-to-rear harness prior to
further disassembly could result in permanent damage to your scooter.
Toggle Latch Release
1. Push in the toggle latch release button while pulling back the toggle latch. See figure 14.
2. Position the toggle latch buckle over the top of the toggle latch. See figure 15.
3. Lower the tiller to the scooter floorboard and fully tighten the tiller adjustment lever.
TOGGLE
LATCH
Figure 14. Toggle Latch (Latched)
30
UNPLUG FRONT-TO-REAR HARNESS
Figure 13. Disassemble Rear Connections
TOGGLE
LATCH
RELEASE
BUTTON
www.pridemobility.com
TOGGLE
LATCH
BUCKLE
Figure 15. Toggle Latch (Unlatched)
Victory/Rev A/March 2004
BATTERY
HARNESSES