Pride Mobility Victory Owner's Manual page 31

V I I I . D I S A S S E M B LY A N D A S S E M B LY
Frame Separation
1. Push back on the seat post to pivot the scooter’s rear
section rearward until the rear section is standing ver-
tically on its rear bumper. See figure 16.
2. Lift the front section up until the lower pegs are no
longer in the slots. See figure 17.
3. Carefully lift the front section vertically away from the
rear section.
ASSEMBLY
1. Position the front and rear sections of your scooter as
shown in figure 18.
2. Align the lower slots of the front section with the cor-
responding pegs on the front of the rear section. See
figure 17.
WARNING! Position the front-to-rear
harness so it won’t become pinched
between the frame halves when
pivoting the rear section forward.
3. Holding the seat post, slowly pivot the rear section
forward until the curved locking brackets are fully con-
nected onto the top rear pegs. See figure 17.
4. Raise the tiller.
5. Secure the toggle latch. See figure 14.
n Lower the toggle latch buckle.
n Push back on the toggle latch so it locks into place.
6. Reinstall the batteries.
7. Connect the front-to-rear harness and both battery
harnesses.
8. Reinstall the rear shroud.
9. Replace the seat and rotate it until it locks into place.
Victory/Rev A/March 2004
Figure 16. Frame Positioning
SLOTS
Figure 17. Frame Lockup
Figure 18. Frame Halves
www.pridemobility.com
PEGS
31