Kubota RCK72P-F39 Operator's Manual page 50

[2WD]
(1) Front gauge wheel
(2) Lift rod
(3) Front roller
(4) Anti-scalp roller
C For adjusting the lift rod tension
To adjust the tension, insert the set pin from A, B, C or D
as shown in the figure.
OPERATING THE MOWER
A If all the spacers are difficult to insert to the lift rod,
remove 1 or 2 spacers. Restore the removed spacer to
the right mower link with a clevis pin and a snap pin.
(1) Shim storage
(2) Shim
(3) Clevis pin
(4) Snap pin
A For easy adjusting of the lift rods, place a wooden
block under the rear end of the mower deck before
lowering the mower deck.
A Cutting height will change because of the ground
condition.
4. Use higher settings for mowing in a rough area or
when mowing high grass. Lower settings should be
used only for smooth lawns where short grass is
desired.
5. Lower the mower deck by pushing the hydraulic
control lever forward. This lowers the mower deck
from the transport position to the operating position.
11