Yamaha RX-V730 Service Manual page 18

RX-V730/RX-V730RDS/RX-V630/RX-V630RDS
HTR-5560/HTR-5560RDS/DSP-AX630/DSP-AX630SE
4. SPEAKERS SET
The input signal is automatically identified and switched in
the priority order of dts → DOLBY DIGITAL → AAC →
PCM AUDIO → Analog (A/D) according to the signal
detection.
The signals output from the DSP block are the same as 1.
DSP THROUGH: YSS 0dB.
MAIN: SMALL 0dB
Front Mix: 5ch
The analog switch settings for each sub-menu are as
shown in the table below.
1 MAIN: SMALL 0dB
2 CENTER: NONE
3 LFE/BASS: MAIN
4 FRONT MIX: 5CH
5 REAR CENTER: POWER
LARGE: This mode is used with a speaker with high
bass reproduction performance (a large
unit). Full bandwidth signals are output.
SMALL: This mode is used with a speaker with low
bass reproduction performance (a small
unit). The signals of 90Hz or less are mixed
into the channel specified by LFE/BASS.
NONE: This mode is used with no center speaker.
The center content is reduced by 3dB and
distributed to MAIN L/R.
Reference data
INPUT: DVD ANALOG (Both ch)
Sub-menu
1 MAIN: SMALL 0dB 1kHz/90Hz Both ch, -20 dBV
2 CENTER: NONE
3 LFE/BASS: MAIN
4 FRONT MIX: 5CH
5 REAR CENTER: POWER 1kHz Both ch, -20 dBV
30
REAR CENTER
Sub-menu CENTER SP REAR SP
LARGE
NONE
SMALL
LARGE
LARGE
Input level Volume
-10 dB +14.8/+11.5 dBV
1kHz Both ch, -20 dBV -10 dB
50Hz Both ch, -20 dBV -10 dB
1kHz Both ch, -20 dBV -10 dB
-10 dB
MAIN SP MAIN LEVEL LFE/BASS
LARGE SMALL
LARGE LARGE
SMALL LARGE
LARGE LARGE
LARGE LARGE
SPEAKER OUTPUT (1kHz)
MAIN L/R CENTER REAR CENTER
- ∞
- ∞
+11.9 dBV
- ∞
+13.0 dBV
- ∞
+19.0 dBV
- ∞ - ∞
+14.0 dBV
LFE/BASS: MAIN
0dB SWFR
0dB BOTH
0dB MAIN
0dB BOTH
0dB BOTH
SUBWOOFER
RL/RR OUTPUT (50Hz)
- ∞ - ∞ - ∞
- ∞ - ∞ - ∞
- ∞ - ∞ - ∞
- ∞ - ∞ - ∞
- ∞ - ∞