General Rules; Nv-600L/R Connections - netsys NV-600L/R User Manual

2.3 General Rules

Before making any connections to the NV-600L/R, note the following rules:
• Ethernet Port (RJ-45)
All network connections to the Router Ethernet port must be made using Category 5 UTP for 100Mbps;
Category 3, 4 UTP for 10Mbps
No more than 100 meters of cabling may be use between the MUX or HUB and an end node.
• Phone Port (RJ-11)
All Phone set connections to the RJ-11 Port must use 24~26 Gauge phone wiring.

2.4 NV-600L/R Connections

The NV-600L/R can be controlled by a PC. For this purpose, a PC is needed with an Ethernet network interface and a
DB-9 RS-232 serial interface. Two programs are required: A Web browser is mandatory and a terminal program should
be available optionally.
The board has several connectors.
• 4 Ethernet RJ-45 jacks; the Auto MDIX feature of the port switches automatically between MDI and MDI-X
(MDI – X = Media Dependant Interface - Crossover). Therefore straight Ethernet cables can be used.
• 2 x RJ-11 jack (Line port is for VDSL client side connection to Line interface, Phone port is for connection to
phone set or FAX machine).
• 1 x Console port (access monitoring to operating system for firmware downloads, starting drivers and etc.)
• 1 Power Supply (as described above)
NV600L/R VDSL2 CO&CPE Router USER'S MANUAL Ver.A15
10